Hanson Research logo
 

Calibration and spares

Calibration

We provide a calibration service for: PM205 and RM744.

Spares and Parts

These parts can be purchased from your local Hanson Research office.

PM205, PM205A and PM205B

Pm205-Psu Rev C

Power Supply unit for PM205, PM205A and PM205B

The latest Firmware is: PM205rf revE.

Note: If your PM205 is pre 1993 this Power Supply will not be compatible.

RF-Module The RF-Module has been designed to detect radio frequencies deemed dangerous to perforating.
Designed and manufactured by CanTrade in Canada.
PM205 Signal Board Rev D

The Signal Board measures the ground integrity. The blue adjustable pots on the board calibrate the voltage, resistance, gain and threshold.

This board should be checked regularly for calibration.

Latest Firmware: TT014

MDM350-PM This display is used for both displays in the PM205.
Switch kit loom These have been supplied in the past for systems which are over 8 years old where the switches have been damaged.
PM6-way male and PM6-way Female

These are the connectors that are used for connection to the rear of the PM205.

These connectors are the standard Mil spec 6way connector. UK pattern 106

Alarm Relay Box

The Alarm Relay Box has been designed to make connection to the external siren and strobe easier.

The Box is powered externally.

MAX. Vin = 30 vdc
MAX. Power = 90 Watts
MAX. Output Strobe = 30 vdc @ 3amps
MAX. Output Siren = 30 vdc @ 3 amps

Top

RM744

Mudcell The complete Mudcell can be purchased, or the following parts can be obtained individually:
  • Silver stage clips.
  • Perspex cover
Display perspex cover  
Battery perspex cover  
Silver cell cover  
Mains input cover  
Selector switch knob  

Top

DM100

Encoder housing The encoder housing seen here with the Magnet wheel is screwed to the shaft of the guide wheel. The housing sends back a digital signal. This is an advantage over older speedo cable designs.
Magnet wheel The Magnet wheel is fitted into the end of the guide wheel. The magnet provides the quadrature pulses that are required for direction and counting.
O ring seal Fits to Encoder housing
Mil spec connector For connection to Encoder
housing

Contact your local supplier for quotations and delivery.

© 2002 Hanson Research Limited.

Contact Us Home Top